I’m obsessed with anything skulls. Always have and always will! So when I saw some skull stakes at Dollar Tree, I had to purchase them! The packaging stated that they were glow in the dark, but when we tried them out later that night, we didn’t see much glow at all. And this was even after we put them in direct light.
Instead of having a dull glow, I thought we could brighten these up ourselves! Opened up the paint cabinet to find some primer and glow in the dark spray paint that I had leftover from another project. & began the impromptu DIY project.
First step is to prime the skull stakes with one to two coats. I sprayed two coats of this Krylon Primer found here. Be sure to let dry completely in-between coats. Next, I sprayed two coats of the Rustoleum Glow in the dark spray paint found here and let dry completely.
Charge in direct sunlight for maximum exposure and decorate! I love how these add a neat effect to our Halloween decorations — I almost want to keep them up all year long! LOL
Have you done any glow in the dark projects? If so, please share below!
We couldn’t wait until October to decorate our first house for Halloween! We both were/are excited and spent the weekend shopping for indoor and outdoor Halloween decorations. One of the items we purchased were these witch hats that we found at the Dollar Tree.
I saw some ideas on Pinterest of people hanging them from the ceiling and I thought it was such a neat idea and had to try it out! & It looked extremely easy to do.
First, you’ll want to take your thread and measure how low you want the hats hanging from the ceiling. Next, you’ll apply the thread to the witch hats either using Glue Dots, Super Glue or Command Strips. I used glue dots and attached them to the string and them secured to the witch hat. Once all were completed, I applied them to the ceiling again using glue dots.
Depending on your ceilings (paint, dust, etc.), you may want to use a command strip and place the thread in between the two to hold. Most of our hats are holding up well, except one — it keeps falling, but I think it’s due to where it’s located and being pushed down by the air vent.
What do you think?! Have you done something similar? Please share below!